Hi Mike,
thanks for replying back.
I hope my answers dont interfere too much with the offical ones, I just try to let you know, which difficulties I have encountered in the past.
Given the SW-Package screenshot I have several thoughts:
(Given the information that the installer-file names need to be named + parameters.)
- Did you try without the parameter?
- Did you try "/S" (a capital S; I have had some cases in which a small /s was not interpreted correctly - this is not DTC's fault but with the software developer)
- Did you try one setup at a time? I don't know and never used a line break to run two installers from one package (I believe this might be a big problem causing the "File not found error"!)
Make sure that no other configurations are activated for that client, preventing the sap setup from beeing executed (which make sit stay as "ready...").
Hope this helps. ;-)